Epson TM-U950 Manual Del Usuario página 2

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written
permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information
contained herein. While every precaution has been taken in the preparation of this book, Seiko Epson Corporation
assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use
of the information contained herein.
Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for
damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of
this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to
strictly comply with Seiko Epson Corporation's operating and maintenance instructions.
Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or
any consumable products other than those designated as Original Epson Products or Epson Approved Products by
Seiko Epson Corporation.
®
EPSON is a registered trademark of Seiko Epson Corporation in the U.S. and other countries
NOTICE: The contents of this manual are subject to change without notice.
Copyright © 2007 by Seiko Epson Corporation, Nagano, Japan.
DIP Switch Tables
Serial interface
SW Function
1-1 Data word length
1-2 Parity
1-3 Parity selection
1-4 ~ Transmission speed (see table below)
1-5
1-6 Display module
connection
1-7 Data receive error Ignored
1-8 Handshaking
Transmission speed
Speed 1-4 1-5
1200 ON ON
2400 OFF ON
4800 ON OFF
9600 OFF OFF
SW Function
2-1 Auto line feed
2-2 Receive buffer
2-3 Font selection
(default)
2-4 Carriage speed
default
2-5 Handshaking
(BUSY)
2-6 Internal use
2-7 I/F pin 6 reset
2-8 I/F pin 25 reset
Parallel interface
SW Function
1-1 ~ Undefined
1-5
ON OFF
7 bits 8 bits
Enabled Disabled
Even Odd
Connected Not
connected
Prints "?"
XON/XOFF DTR/DSR
ON OFF
Always Always
enabled disabled
32 bytes 2048 bytes
9 × 9 7 × 9
Low High
Receive Offline or
buffer full receive
buffer full
Fixed —
Enabled Disabled
Enabled Disabled
ON OFF
— —
Parallel interface
SW Function
1-6 Internal use
1-7 ~ Undefined
1-8
SW Function
2-1 Auto line feed
2-2 Receive buffer
2-3 Font selection
(default)
2-4 Carriage speed
default
2-5 Handshaking
(BUSY)
2-6 Internal use
2-7 Undefined
2-8 Internal use
ON OFF
— Fixed
— —
ON OFF
Always Always
enabled disabled
32 bytes 2048 bytes
9 × 9 7 × 9
Low High
Receive Offline or
buffer full receive
buffer full
Fixed —
— —
Fixed —