Descargar Imprimir esta página

Olimpia splendid CALDO UP T Instrucciones Para El Uso Y El Mantenimiento página 42

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 85
In this condition, when the appliance is in heating mode or in set temperature mode
(the function is cannot be activated in functioning as fan), if it detects an ambient tem-
perature reduction by a few degrees, the function activates.
To enable the function:
a. When the appliance is connected to the mains power and in heating mode, press
to enable the WINDOW/DOOR OPEN function. The LED TEMP turns on on
the display.
b. Press
Each time the appliance is electrically connected, the WINDOW/DOOR OPEN
function is deactivated.
If this function is disabled, the appliance works normally.
Temperature detection starts 1 minute after the open window/door detection.
The function activates with a round which lasts 10 minutes and every 5 minutes the
appliance detects ambient temperature to check if the window/door has been closed.
If, during the checks, the appliance detects:
• a difference of ≤8°C compared to ambient temperature, it keeps heating and the
open window/door detection continues,
• a difference of >8°C compared to ambient temperature, it stops heating and switches
to stand-by mode and the open window/door detection stops.
Note:
• When the appliance stops heating, the alarm report and the fan keep functioning for
30 seconds, then they switch to stand-by mode. Both the LED TEMP and the writing
flash on the appliance display.
- Press
- After restart, the open window/door detection starts again in the same ways previously
described.
- Press
and the LED °C turns on (appliance in stand-by).
4 - OVERHEAT PROTECTION
• This heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating.
In this case:
- unplug the appliance;
- wait about 15/20 minutes for it to cool;
- remove any possible cause of overheating, eg. something covering the heater;
- check for damage to the appliance, the cord and the plug.
EN - 18
a second time to disable the function.
to restart the appliance before it turns off.
to turn the appliance off; the display resume showing ambient temperature

Publicidad

loading