FEIDER Machines FG1600i Manual De Instrucciones página 29

STARTING THE ENGINE
ATTENTION!
Always check the oil level before starting the engine(see Page 5). Perform the specified daily inspection to
see if it is in normal condition.
Before starting, disconnect all load from the DC terminals.
Step 1: Turn Fuel Cock to ON position.
Note: The fuel cock on/off switch connects/cuts-off the fuel feed
from the tank.
FIG. 6
Turn fuel cock to ON position (FIG. 6) and wait for at least one FUNCTIONING
minute until the liquid fuel flows into the carburetor.
Step 2: Turn engine switch to ON position.
Note: This engine switch is an electronic ignition.
The switch "O" position means OFF, "I" position means ON.
Turn engine switch to ON position (FIG. 7)
FIG. 7
Step 3: Pull the choke lever to CLOSED position.
Note: Pull the choke lever to CLOSED position (FIG. 8) for the carburetor to better blend the air and fuel
while starting the engine. Pull the choke lever to OPEN position (FIG. 9) to increase the amount of air in
the fuel mixture after the engine is started.