Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
14
ENGLISH
Possible cause
Door was not closed completely.
Stored food was not wrapped.
Food products prevent the water
from flowing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
There is no cold air circulation in the
appliance.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
3. If necessary, replace the defective door
Solution
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Refer to the "Closing the door" sec‐
tion.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
the "Hints and tips" chapter.
"Installation" chapter.
gaskets. Contact the Authorised Service
Centre.
Publicidad
