Publicidad
Idiomas disponibles
Idiomas disponibles
Pump function is activated for 1-2 minutes regardless of the program step, and whether there is
water in the machine or not. After this period, your machine will be ready to start with the first step
of the new program.
Depending on the step where the program was canceled in, you may have to put
detergent and softener again for the program you have selected anew.
END OF PROGRAMME
"End" appears on the display at the end of the program. Wait until the loading door light illuminates
steadily. Press On / Off button to switch off the machine. Take out your laundry and close the loading
door. Your machine is ready for the next washing cycle.
MAINTENANCE AND CLEANING
Service life of the product extends and frequently faced problems decrease if cleaned at regular
intervals.
CLEANING THE DETERGENT DRAWER
Clean the detergent drawer at regular intervals (every 4-5 washing cycles) as shown below in order
to prevent accumulation of powder detergent in time.
1. Press the dotted point on the siphon in the softener compartment and pull towards you until the
compartment is removed from the machine.
If more than normal amount of water and softener mixture starts to gather in the
softener compartment, the siphon must be cleaned.
2. Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to avoid touching of the residues in the drawer
with your skin when cleaning.
3. Insert the drawer back into its place after cleaning and make sure that it is seated well.
If your detergent drawer is the one indicated in the following figure:
Lift the rear part of the siphon to remove it as illustrated. After performing the above-
mentioned cleaning procedures, replace the siphon back to its seating and push its
front section downwards to make sure that the locking tab engages.
87
Publicidad
