GYS GYSPACK AIR Manual Del Usuario página 13

Translation of the original instructions
• The terminal of the battery that is not connec-
ted to the car frame must be connected
first. The other connection must be made
on the car frame, far from the battery and
the fuel line. The battery charger must be
connected to the power supply network.
• After the charging process, disconnect the
battery charger from the power supply
network and remove the connector from
the car frame and then the connector from
the battery, in this order.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact
with battery acid, rinse the affected part
of the body with plenty of water and seek
immediate medical assistance.
Connection:
• Class II device (charger booster)
• Class III device (booster)
• Connection to the mains must be made
according to the national installation re-
gulations.
Maintenance:
• If the charging / power supply cable is
damaged, the product must be disposed.
• Service should be performed by a quali-
fied person
• Warning! Always disconnect from the
mains before performing maintenance on
the device (charger & booster).
GYSPACK AIR EN
13