Publicidad
Idiomas disponibles
Idiomas disponibles
5. Troubleshooting
In the event of malfunctioning of the Shears, look for the causes in the following way:
Startup
Opening operation
Cutting cycle
Close stop
Warning
Charging *
Auto power off
*For proper safety, charge the battery only with the device disconnected.
Problem
The battery does not turn on
The Shears have stopped in work
The Shears do not work
The Shears have little cutting power
or cut badly
The Shears heat up excessively
The battery does not last long
** lf the problem is not solved, you must go to your distributor and/or nearest Authorized Technical Service.
ACOUSTIC SIGNALS
Action
Press the button (3) for 1 second
Cutting trigger (1) pressed for 3
seconds
Cutting trigger (1) pressed + button
(3) for 0.5 seconds with blade
closed)
Cutting trigger (1) pressed twice in
quick succession, then held down
with the blades closed
During the work
Connect to the battery charger
-
INCIDENT DIAGNOSIS
Cause
The battery is low
Overexertion (stop in cutting) ("a", "b", "c"
paragraph 3.8)
The Shears are not properly connected
to the battery
The battery charge is very low
The device connection cable is faulty
Hardware fault
The cutting blade is very worn or
notched
The counter blade is highly worn
The cutting blade is highly worn or
notched
The counter blade is highly worn
Kept the cutting blade is highly worn
or notched
The counter blade is highly worn
The charger does not work
Acoustic signal
3 beeps
Battery on (device still not recognised)
1 beep
1 short beep
Blade opening (Shears ready for use)
1 beep
1 beep
Shears in standby (blades closed position)
1 beep
4 beeps
3 beeps
3 beeps
Possible solution **
The Shears have an overdue is in limit to protect the
equipment. In the case of overexertion, the Shears stop
automatically. Perform less heavy-duty cutting cycles.
Make sure the Shears are properly connected to the battery
Make sure the batteries are charged
Replace the connection cable
Contact the Service Centre
Keep the blade sharpened at all times
Check and change if necessary
Check and change if necessary or sharpen
Check and change if necessary or sharpen
Keep the blade well sharpened at all times
Check and change if necessary or sharpen
Check the state of the charger.
State of the tool
Battery on (device recognised)
Blade opening change
Excessive strain (b par. 3.8)
Alarm (c par. 3.8)
Shears disabled
Off
Re-charge
41/64
Publicidad
