Anker Solix Serie Manual De Instalación página 30

1. Mount the solar panel support beams on the solar panel.
A x2
1160 Solar Panel Support Beam
mm
2. Install the vertical support scaffoldings and solar panel support beams without tightening the screws.
B x2
1006 Vertical Support Sca olding
mm
H x2
M6×14 Hexagon Flange Bolt
53 EN
H x4 J x4
M6×14 Hexagon Flange Bolt M6 Flange Nut
3. Mount the lower support beams and adjust the angle for maximum sunlight exposure.
Note: Make sure that both ends of the lower support beams are aligned with the same number.
H x4
C x2
600
Lower Support Beam M6×14 Hexagon Flange Bolt
mm
4. Align the solar panel with the holes on the vertical support scaffoldings to mark four mounting points. Mounting points on the
same vertical support scaffolding should be 800mm (31.4in) apart.
5. Remove the solar panel, mark the mounting points, and drill the holes 63mm (2.4in) deep with an electric drill. Then, secure
the scaffolding with nuts.
Note: The vertical scaffolding should be secured with anchors to prevent them from falling.
J x4
G x4
M6 Flange Nut
M6×100 Hexagon Flange Bolt
B
C
°~ °
45 40 35 30
A
��mm
EN 54