Operation
Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (3) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Checking the battery
charge level
The battery's (4) charge level is indicated
by the charge state indicator (18).
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (2).
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs
Recharging the battery
Allow a hot battery to cool before
charging.
Charge the battery (4) when only
the red LED on the level indicator is
illuminated.
PAPK 12 A1
Charging
PAPK 12 A2
time (hours)
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
to be charged
PAPK 12 B1
PAPK 12 B2
1
2
1
2
0,5
1
1. Remove the battery (4) from the appli-
ance.
2. Plug the battery charger (27) into a
mains outlet.
3. Insert the battery (4) in the charging
compartment of the battery charger
(27).
4. After charging is complete, a green
light will be illuminated permanently.
You can now disconnect the charger
(27) from the mains supply.
5. Unplug the battery charger (27) from
the mains.
Checking the function of
the protective hood
• Pull the pull lever for the protective
hood (
23) back as far as it will
go. The protective hood (9) must move
freely without jamming and jump back
to the original position automatically
when the pull lever for the protective
hood (
23) is released.
•
Always keep the protective hood
(9) free of sawdust to keep it from
jamming the mechanism.
Installing/changing the
saw blade
Switch off the device and remove
the battery before carrying out any
work.
1. Set the cutting depth to the minimum
position, 0 mm (using the retaining
screw (6) ).
2. Using the pull lever for the protective
hood (23), move the protective hood
back and switch the device off.
3. Press and hold down the spindle lock
(15).
GB
IE
29