MSG Equipment MS900 Manual De Usuario página 24

English
MS900 stand
Figure 23
3. Open the valves (item 1 in Figure 23) and drain all the water from the tank.
4. Once the water has been drained, close the valves (item 1 in Figure 23), disconnect the flexible
hose, and place the stand panel back in its position.
7.6. Software update
The process of updating the software for the MS900A and MS900B modules is the same. To update
the software, you will need a USB Type-C flash drive with a capacity of up to 32 GB (maximum),
formatted in the FAT32 file system.
The software update procedure is as follows:
1. Copy the update file to the root directory of the USB flash drive.
2. Open the door with the touch panel.
3. Connect the USB flash drive to the USB port on the module's board (refer to Figure 24).
4. Go to the settings menu and press the "Update" button.
5. Wait for the update process to complete.
WARNING! It is prohibited to interrupt the update process by disconnecting the power or
removing the USB flash drive.
24