monzana Alissa Manual De Instrucciones página 8

• Make sure that the lamp is switched off and cooled before touching it. Bulbs generate a lot of
heat.
• Only use the specified types of bulbs.
• Do not look directly into the light source.
GENERAL SAFETY INFORMATION – ELECTRICAL SYSTEM
• CAUTION! Read all safety information and instructions. Failure to follow the safety information
and instructions may cause electric shock, fire and/or serious injury.
• Ensure that water cannot get inside the appliance. Never immerse the appliance in water or
other liquids. Never expose it to rain.
• Do not use the appliance if the mains plug, mains cable or any other part of the appliance is
defective or damaged.
• Do not use the product if it has previously been dropped.
• Do not use the pump if it exhibits visible signs of damage.
• Do not remove the mains plug from the socket by pulling on the mains cable.
• Never insert or remove the mains plug with wet hands.
• This appliance may be used by children over the age of 8 and by individuals with reduced
physical, sensory or mental capabilities or a lack of experience and knowledge, provided that
they are supervised or have received instructions on the safe use of the appliance and
understand the risks involved. Children must not play with the appliance. Do not allow children
to clean the appliance or perform user maintenance without supervision.
• Do not use any electrical appliances in potentially explosive environments, e.g. in the presence
of flammable liquids, gases or dust. Electrical appliances produce sparks that can ignite dust or
exhaust fumes.
• The plugs of electrical appliances must be compatible with the socket. Never change the plug.
Do not use adaptor plugs with earthed electrical appliances. Original plugs and matching
sockets reduce the risk of electric shock.
INTENDED USE
The floor lamp is only to be installed indoors as well as outside of wet rooms. Use the product
only for the purpose it is intended for. The manufacturer accepts no liability for damage caused
by improper use. Any modification to the product may negatively impact safety, cause hazards
and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product. After unpacking, please check the product for damage
and to ensure it is complete. Subsequent complaints cannot be accepted.
ASSEMBLY (See graphic on page 2)
1. Screw the socket (7) onto the rod (4).
2. Place the lamp shade (5) on the socket (7) and screw it tightly together with the lamp ring (1).
3. Place the lamp shade (6) on the socket (4) and screw it tightly together with the lamp ring
(8).
4. Screw the rods (3) on the rod (4) and connect these to the base (2).
5. Secure the cable clamps (9) to the rods (3) and secure them to the power cord.
8 www.DEUBAXXL.de