Intended Use; General Safety Instructions - monzana 108933 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

INSTRUCTIONS
6
ATTENTION! Read the safety and assembly instructions carefully, in order to
avoid the risk of injury or damaging the product.
Important: Read these instructions carefully and thoroughly. Keep these
instructions to read through at a later date. If you give the product to
anyone else at some point in the future, please ensure you also pass on this
manual
Only for domestic use and not for
commercial use!
Keep small parts, plastic bags and other packaging out of the reach of children.
Pay attention especially when unpacking your item. Danger of suffocation!
Check the delivery for completeness. Later complaints cannot be accepted.
Check all elements and parts for damages. Despite careful control, products may be
damaged in transit. In this case, do not assemble your product. Defective parts can en-
danger your health.
Never modify the product! Changes will void the warranty and the product may be
unsafe or even dangerous.
Unpack all the parts and elements of the set and place the components on the top of
the carton or other clean surface. This protects your new product.
Please also pay attention not to scratch the floor while working with tools.
Make sure that this product is fully assembled before use, as shown in the illustration
For cleaning use a sponge and warm soapy water.
Do not use solvent based-cleaners or detergents - for example bleach. Those can dam-
age the product.
Use the product only for its prescribed purpose. This lamp is only available in To be
installed indoors and outside wet areas. The table lamp is operated via mains voltage
(see Technical Data). The manufacturer accepts no liability for damage caused by
improper use. Please adhere explicitly to the safety instructions and other information
contained in these instructions.

General Safety Instructions

No fragile glass parts in the product, safer and more secure
Before use, check that the power supply corresponds to that which is stated on the
device's nameplate. Avoid any unintentional startup.
Do not allow water or other liquids to get into the appliance. Do not expose it to
rain.
S
aves more than
S
traditional bulbs

Intended Use

No fragile glass parts in the product, safer and more secure
d
oes not hurt
a
nti-glare
n
atural light
aves more than
d
oes not hurt
a
nti-glare
the skin
filter
Do not use the appliance if the plug, the mains cord or other components are
damaged.
If the mains cord is damaged, you must have it replaced by a service centre authorized
or similarly qualified persons in order to avoid a hazard. Otherwise there is a risk of
electric shock. Never try to repair the appliance yourself.
Never plug in or unplug the mains plug when your hands are wet.
Avoid pulling the cord when removing the plug from the socket. Instead, hold the
plug.
Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or
put under mechanical stress. Avoid excessive thermal stress on the mains cable from
extreme heat or cold. Do not modify the mains cable. Otherwise the mains cable
may be damaged. A damaged mains cable can cause a deadly electric shock.
This device is not intended for use by persons (adults and children) with physical,
sensory or mental impairments or lacking experience and/or knowledge of use
unless they are supervised by a person responsible for their safety or have received
instructions from that person on how to use the applicator. Children should be
supervised to make sure they do not play with the device.
The LED's cannot be replaced!
Use the lamp indoors only!
The lamp can be used in three brightness levels. When the switch is pressed a second
and third time, the brightness increases, and a fourth time, the lamp turns off again.
The M button toggles between warm white, cool white and sunlight. The brightness levels
work independently of the light color.
Note: Wireless charging and USB charging cannot be used at the same time.
After the desk lamp is powered on, wireless charging can be used normally. Please put
the mobile phone with wireless charging function in the wireless charging area. The
indicator light on the desk lamp base lights up and the mobile phone starts to charge.
n
atural light
Start-up
• Insert the power transformer into the power socket
at the rear of the lamp arm
• It is possible to charge cell phones, tablets and other
digital products using USB power.
The output power is 1000mA.
Turn on the power at the touch of a button
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mzsl01

Tabla de contenido