Faro Barcelona 333523L Manual Del Usuario página 16

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / Ο∆ΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
ELECTRICAL CONNECTIONS
OPERATION & MAINTENANCE
Operating
Connect electricity and test the ceiling fan. The Fan Pull Cord controls power to the fan. It has four settings in
sequence:
1 high
2 medium
3 low
4 off
The reversing switch for hot or cold weather depends on factors such as the size of the room, height of the ceiling,
number of ceiling fans, etc. The reversing switch controls the direction of the fan.
Hot weather/downward –The fan will turn in a counter clockwise direction. A downward air circulation creates a
cooling. This allows you to regulate the air conditioner to a higher temperature without affecting your comfort.
Cold weather/upward – The fan will turn in a clockwise direction. An upward air circulation will distribute the
warmer air trapped at the ceiling around the room without causing a draft. This allows you to regulate the heating
to a lower temperature without affecting your comfort.
NOTE: To change the direction of air flow, turn the fan off and let it come to a complete stop.
Maintenance
1. As fans tend to move during operation, some connections may loosen. Check the supporting screws, brackets
and blade attachments twice a year to ensure that they are secure.
2. Cleaning the fan helps to maintain its appearance for years. Do not use water when cleaning. This could
damage the motor or the blades and could cause electrocution.
3. Use a soft brush or lint-free cloth to prevent scratching the surface.
4. There is no need to oil the motor as the bearings are permanently lubricat.
TROUBLE-SHOOTING GUIDE
The fan does not start:
1. Check the fuses and circuit breakers.
2. Review the connections of the terminal block according to the indications in the installation.
Ensure the power is off before doing this.
3. Make sure that the sliding switch is firmly in the position of up or down. The ventilator does not work when
the button is in the middle.
4. Make sure that the stabilizing tongue-pieces of the motor are off.
5. Finally if the fan will not start call an electrician do not attempt to touch the internal parts.
The fan is noisy:
1. Check that the screws in the motor casing are attached correctly.
2. Check that the screws fastening the blade brackets to the engine block are properly tightened.
3. If using an optional light fitting, ensure the glass is properly fitted and / or the screws holding the glass
are firm.
4. If a solid state speed control has been fitted this can cause noises in the motor do not use these control.
5. Allow at least 24 hours for the fan to settle, as many noise will go away. Each blade set is weighed and is
a complete set, if installing more than one fan do not mix the blades as this can cause wobble.
Cuba ref. 33352 faro - 15