Dräger FPS IMD Instrucciones De Uso página 20

en |
Description
Dräger PC Link software can be used to configure the In-Mask Display.
There is a rechargeable battery in the In-Mask Display. This battery can be
charged in the associated charging cradle. In stationary operation, the charging
cradle can be connected to the mains via the supplied plug-in power supply unit.
When the charging cradle is installed in a vehicle, the vehicle adapter is used.
3.3 Meaning of the LEDs
LED on In-Mask Display
LED
Lights green
Lights green for
5 seconds at switch-on
Lights yellow for
5 seconds at switch-on
Lights yellow
Lights red
Lights red for 5 seconds
Slowly flashing red
(2 Hz)
Rapidly flashing red
(4 Hz)
Flashes blue
LEDs on the charging cradle
There are 4 LEDs on the charging cradle which indicate the status of the
charging process.
LED
LED 1 lights green
All 4 LEDs light green
20
Meaning
The battery charge is more than 50% and the In-
Mask Display is in Standby mode.
The battery charge is more than 50%.
The battery charge is 26% to 50%.
The In-Mask Display is in Standby mode and the
battery charge is 26% to 50%.
The In-Mask Display is in Standby mode and the
battery charge is 0% to 25%.
The battery charge is less than 25%, but is sufficient
for a further 5 minutes.
The battery charge is sufficient for less than 2 hours.
– Overheating of the In-Mask Display and possibly
of the thermal imaging camera
– Error in the In-Mask Display
New firmware is being initialised on the In-Mask Dis-
play.
Meaning
The charging cradle is ready for operation.
The battery is fully charged.
Dräger FPS IMD