Bosch KTS 515 Descripción Del Producto página 16

en | 16 | KTS 515 | Description of unit
3.5 Operation
The KTS 515 can be connected to a PC/Laptop by
way of a radio link (Bluetooth) or the USB interface.
For a radio link, the Bluetooth USB adapter has to be
plugged into the PC/Laptop.
3.5.1 Connection diagram
1
9
2
10
3
11
12 4
13 5
14
6
15
7
16
8
8
X9
V
BOSCH
I
D
E
O
X2 Mouse X7 LPT1
X25 USB1
1
X1 K ayboard X3 COM1 X4 COM2
0
X26 USB2
7
6
4
Fig. 3: Connection diagram with KTS 515
1 OBD interface in vehicle
2 OBD diagnostic cable
3 KTS 515
4 Adapter insert (IBOX 01)
5 Power supply unit
6 USB connecting cable
7 Bluetooth USB adapter
8 PC (Laptop)
|
1 689 989 232 2023-01-24
1
2
3
5
3.5.2 Notes on on-board diagnosis
The KTS 515 is supplied with voltage either via the
power supply unit provided or the OBD interface in
the vehicle.
!
If a test step involves starting the engine, the
battery voltage may drop to such an extent that
supply is no longer guaranteed by way of the
vehicle. In such cases it may be necessary to run
the KTS 515 by way of the power supply unit.
i
On some vehicles, the ignition must be switched on
for power to be supplied via the OBD interface.
Connection to the diagnostic interface in the vehicle is
made by way of
R
The OBD diagnostic cable (fig. 3, item 2)
!
Make sure the OBD diagnostic cable is properly
connected to the KTS 515. Incorrect connection
could cause the pins of the connector to bend
or break off. Only use the OBD diagnostic cable
contained in the scope of delivery.
i
Notes on control unit diagnosis can be found in
the Online Help for the "on-board diagnosis" PC
software.
3.5.3 Firmware update
For information on the firmware update, see
KTS 515 Help Center:
https://help.boschdiagnostics.com/KTS515/#/home/KTS515FirmwareUpdate/
en/default
Robert Bosch GmbH