Metabo HPT CB 18DBL Instrucciones De Seguridad Y Manual De Instrucciones página 15

NOTE
○ Using a soft cloth, wipe off any foreign matter that has
adhered to the lens of the LED light, being careful not
to scratch the lens.
Scratches on the LED light may reduce the brightness
of the light.
○ When cleaning the lens of the LED light, do not wipe
with gasoline, paint thinner, etc.
Doing so will damage the lens.
7. About remaining battery indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 10)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The Table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
State of lamp
The battery remaining power is
enough.
The battery remaining power is
a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator switch
Switch Panel
Table 5
Battery Remaining Power
Remaining battery
indicator lamp
Fig. 10
NOTE
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
○ Unless the power is switched on after installing the
battery to the unit, remaining battery indicator lamp
will not light up when the remaining battery indicator
switch is pressed.
8. Adjusting operating speed (Fig. 11)
CAUTION
Use the band saw blade circumferential speed
setting dial to select the circumferential speed
best suited for the workpiece.
Using a band saw blade circumferential speed
unsuited to cut a workpiece will not only
negatively aff ect cutting precision, but can also
cause damage to the band saw blade.
This unit is equipped with an electronic control circuit
that allows the circumferential speed of the band saw
blade to be freely adjusted.
Prior to operation, use the band saw blade
circumferential speed setting dial to set a mode that
suits the properties, thickness and task conditions of
the workpiece being cut.
○ In Standard Mode, the circumferential speed or
the band saw blade can be freely set from 1 to 5
on the dial.
On the dial, 1 is the lowest speed and 5 is the
highest speed.
In Standard Mode, the circumferential speed that
is set with the dial is maintained even when the
load changes.
○ In AUTO Mode ("A" on the dial), noise can be
reduced and the duration of operation can be
extended by lowing the circumferential speed
when there is no load.
In AUTO Mode, if a load is applied during operation,
the circumferential speed is automatically
increased. (Equivalent of 5 on the dial)
Additionally, if the load becomes lighter after
cutting is completed, the circumferential speed
is automatically decreased, reducing power
consumption when there is no load.
English
15