Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000155-001.book Page 12 Thursday, January 30, 2014 9:05 AM
en
12
Assembly instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
For all work or when changing application tools, always wear protective gloves.
CAUTION
Danger of injury from the sharp edges of the application tools. Application
tools can become very hot while working. Danger of burns!
Changing the tool (FMT250)
(figure 2).
The application tool can be offset in 45° steps
and fastened in the most favorable working
position.
Screw out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Screw in the fastening element to the stop.
Changing the tool (FMT250Q)
(figure 3).
The application tool can be offset in 45° steps
and fastened in the most favorable working
position.
Protect your hand and fingers
CAUTION
against bruising when locking
the clamping lever. The clamping lever snaps
back vigorously by means of spring force.
Release the clamping lever and tilt it to the
stop.
Pull out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Firmly press in the fastening element to
the stop. Then lock the clamping lever.
Fig. 2
Clamping screw
Application tool
Tool holder
Fig. 3
Fastening element
Application tool
180°
Tool holder
Quick-clamping lever
Publicidad
