Publicidad
Idiomas disponibles
Idiomas disponibles
Mobile EV Charger EVSE User Manual
OPERATION
The Mobile EV Charger is very easy to use. Plug the EVSE into any
grounded 120V dedicated outlet, ensuring the receptacle and plug
have a snug fit. Unwrap the SAE J1772 charge cable and plug the
charge coupler firmly into the vehicle's charge port. Always plug
the EVSE into the wall socket first.
Normally, the vehicle will immediately request a charge using a
special communication line in the cable. Within a few seconds the
charging cycle will begin, and the green 'Charging' light will turn
on. The vehicle battery pack will require several hours (length of
time depends on the vehicle acceptance rate, battery pack size
and the vehicle's state of charge) to fully recharge after an average
driving day. Charging overnight is the most convenient way to
maintain healthy batteries and ensure the vehicle's full range will
be available for the next day. It is also the time of day when power
is typically the least expensive to charge your car.
When the vehicle has stopped charging the green "Charging" light
on the Mobile EV Charger will turn off. When disconnecting the
EVSE, always remove the vehicle connector first, then remove the
plug from the wall socket. Do Not unplug from the wall while the
vehicle is still connected.
To remove the charge coupler once a charge cycle has completed
(or to interrupt a charge in progress) press and hold down the latch
release lever on the charge coupler handle then unplug the charge
coupler from the vehicle charge port. When not in use, the cord
should be neatly stowed away.
If charging always takes place in the same location, such as the
home garage at night, the Mobile EV Charger may be left plugged
into the wall socket without damage.
If the EVSE will be moved often, it is highly recommended that a
hospital grade outlet is used as they are more robust.
Page 10
Publicidad
