La Nordica FALO Manual Del Usuario página 11

We thank you for having chosen our company; our product is a great heating solution developed from the most advanced
technology with top quality machining and modern design, aimed at making you enjoy the fantastic sensation that the heat
of a flame gives, in complete safety.
WARNINGS
This instructions manual is an integral part of the product: make sure that it always accompanies the appliance, even if
transferred to another owner or user, or if transferred to another place. If it is damaged or lost, request another copy from the
area technician. This product is intended for the use for which it has been expressly designed. The manufacturer is exempt from
any liability, contractual and extracontractual, for injury/damage caused to persons/animals and objects, due to installation,
adjustment and maintenance errors and improper use.
Installation must be performed by qualified staff, which assumes complete responsibility for the definitive installation
and consequent good functioning of the product installed. One must also bear in mind all laws and national, regional,
provincial and town council Standards present in the country in which the appliance has been installed, as well as the
instructions contained in this manual.
The Manufacturer cannot be held responsible for the failure to comply with such precautions.
After removing the packaging, ensure that the content is intact and complete. Otherwise, contact the dealer where the appliance
was purchased.
All electric components that make up the product must be replaced with original spare parts exclusively by an authorised after-
sales centre, thus guaranteeing correct functioning.
SAFETY
Š DO NOT TOUCh PARTS OF ThE PLANT WhEN yOU ARE BAREFOOT OR WhEN PARTS OF ThE BODy ARE WET
OR DAMP.
Š ThE SAFETy AND ADJUSTMENT DEVICES MUST NOT BE MODIFIED WIThOUT ThE AUThORISATION OR
INDICATIONS OF ThE MANUFACTURER.
Š DO NOT PULL, DISCONNECT, TWIST ELECTRIC CABLES.
Š IT IS ADVISED TO POSITION ThE POWER SUPPLy CABLE SO ThAT IT DOES NOT COME INTO CONTACT WITh
hOT PARTS OF ThE APPLIANCE.
Š DO NOT LEAVE ThE PACKAGING ELEMENTS WIThIN REACh OF ChILDREN OR UNASSISTED DISABLED
PERSONS.
CONNECTION AND MAINTENANCE OF VENTILATION (OPTIONAL)
The control unit and the plant must be installed and connected by authorized personnel according to the standards in
force. (see chapter GENERAL REMARKS).
ATTENTION: the control unit and the feeding cable must not be in contact with hot parts.
On our products, it is possible to install OPTIONAL ventilation kits suitable to improve the distribution of heat by ventilation only either of the
installation room or of the adjacent local.
The Kit is made up of a centrifugal fan, a lighting and adjustment control unit, and a (TM) thermostat that lets the fan start when the device is
properly heated and lets it stop when the fan is partially cold.
The lighting and the adjustment is carried out through the proper standard supplied control unit that has to be installed far from any direct
heat source.
CONNECTION (see Picture 1):
Connect the feeding cable of the switchboard with an electronic bipolar switch respecting at least a 3 mm distance between the contacts
(power supply 230V~ 50 hz, it is necessary to provide for the correct connection to the grounding plan).
IMPORTANT: the FAN ELECTRIC CONTROLLER must be powered with a main differential switch upstream in accordance with
current regulations. The correct operation of the control is guaranteed only for the dedicated motor for which it was built. Improper
use relieves the manufacturer from any liability.
ENGLISH 11