Publicidad
Idiomas disponibles
Idiomas disponibles
en
Please fold out the picture page!
Starting up
Illustration 1
a) Fit the turbo brush onto the suction pipe.
b) Push the telescopic pipe into the supports of the turbo
brush until it audibly engages. Press the unlocking
sleeve and pull out the telescopic pipe to remove it.
(Equipment will vary with each model).
Vacuuming with the brush
!
Please observe!
Only vacuum using the brush on full suction power, i.e.
max. performance of the vacuum cleaner.
Illustration 2
If the turbo brush is vacuuming too strongly, i.e. the slide
force is too high, you can change the slide force by
setting the suction power position, thus enabling an
optimum cleaning effect for the different floor coverings.
=> long pile carpets
=> short pile carpets
Illustration 3
Only brush the fringes in the direction of the arrow.
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
Maintenance
Always switch off the vacuum cleaner and pull out the plug
before performing any maintenance work. Remove the
turbo brush from the suction / telescopic pipe.
Illustration 4
Cut off any wrapped around hair or threads using a pair
of scissors.
Subject to technical change without notice.
15
Publicidad
