Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL SPECIFICATIONS
Model No.
18670-0123
18670-0923
18670-0943
* Length of run is combined length of positive and negative conductors from power source to pump and back to ground. Wire size is SAE gauge and metric (millimetres²).
EXPLODED VIEW
VUE ÉCLATÉE / EXPLODIERTE ANSICHT / VISTA ESPLOSA / UITGEBREIDE WEERGAVE / SPRÄNGVY / VISTA EXPLOTADA
MAINTENANCE
Check wires and connections to be sure corrosion is not adding ad-
ditional resistance to the motor circuit and causing a low voltage con-
dition at the motor. Low voltage can inhibit motor from starting and
cause fuse to blow. Full voltage should be available to prevent motor
damage.
NOTICE: If pump is idle for extended periods, the impeller may stick to
the pump body, preventing motor rotation and causing blown fuses. To
correct, remove end cover and impeller, clean body and impeller, then
lubricate with water or small amounts of grease before assembly.
If pump is to be in freezing temperatures, drain by loosening end cover
screws.
A Service Kit, or at least spare impellers, should be carried aboard to be
assured of pumping capability.
DISASSEMBLY
1. Remove end cover screws, end cover and O-ring.
2. Withdraw impeller.
3. Loosen and remove two slotted hex screws, which attach body to
motor.
4. Tap body lightly between ports and remove body from motor.
5. With a 1/2" (13mm) diameter dowel, push against the shaft seal
from back (motor) side of the body to dislodge it from the seal bore.
NOTE: Do not tamper with or disassemble motor.
– MINIMUM WIRE SIZE
AMP
VOLTAGE
DRAW
12 Vdc
11.5
12 Vdc
11.5
24 Vdc
5
WIRE SIZE PER FEET OF RUN*
FUSE
SIZE
0'-10'
20
#14 (2.5)
20
#14 (2.5)
10
#16 (1.5)
PARTS LIST
Key
Description
1
Screw Kit (End Cover)
(3 screws/kit)
2
End Cover
3
O-Ring*
4
Impeller*
5
Seal*
6
Body
†
7
Slinger
8
Motor
Model 18670-0123 12V
Model 18670-0943 24V
9
Screw (Pump to Motor)
10
Port Adapter Kit (2 each)
Service Kit
* Parts Contained in Service Kit.
† When replacing a pump body that uses a round end cover (3 hole pattern) it is also necessary to replace the end cover,
screws and replace the gasket with an O-ring (order keys 1, 2 & 3).
3
10'-20'
20'-30'
#12 (4)
#10 (6)
#12 (4)
#10 (6)
#16 (1.5)
#16 (1.5)
Qty.
Part Number
1
1
1
1
6303-0003-P
1
1
1
1
2
1
30'-40'
#10 (6)
#10 (6)
#14 (2.5)
91004-0090
18647-0000
18753-0660
18753-0384
18645-0000
6342-0000
18753-0050
18753-0051
98019-0020
18753-0103
90061-0031
Publicidad
