KALLISTA P22121 Guia De Instalacion página 4

Handle
Escutcheon
2. Install the Handles
Remove the handle nut (for lever handle models only).
Turn the bonnet counterclockwise and remove from the valve.
Thread the shank nut down the valve to allow for the thickness
of the mounting surface.
Close the valve (clockwise for hot and counterclockwise for cold).
From below the mounting surface, slide the shank of the valve
through the correct (hot = left, cold = right) mounting hole.
Thread the bonnet back onto the valve, making sure the handle
stays in the closed position and is properly aligned.
Tighten the valve shank nut with a wrench, keeping the handle in
the final installation position.
Adjust the handle to the desired closed position.
Reinstall the handle nut. Tighten carefully.
Repeat the steps above to install the remaining handle assembly.
1004811-2-A
All manuals and user guides at all-guides.com
Handle
Nut
Bonnet
Shank
Shank
Nut
4 Kallista