Shure Microflex MX396 Manual Del Usuario página 8

Replacement Parts
Specifications
All measurements taken with microphone mounted on a wooden surface (76 x 76 cm)
Cartridge Type
Electret Condenser
Frequency Response
50–17000 Hz
Polar Pattern
MX396/C-DUAL Cardioid (x2)
MX396/C-TRI Cardioid (x3)
Output Impedance
170 Ω
Output Configuration
Active Balanced
Sensitivity
@ 1 kHz, open circuit voltage
−35 dBV/Pa (18 mV)
1 Pa=94 dB SPL
Maximum SPL
1 kHz at 1% THD, 1 kΩ load
122 dB
Equivalent Output Noise
A-weighted
30 dB SPL
Signal-to-Noise Ratio
Ref. 94 dB SPL at 1 kHz
64 dB
Dynamic Range
8
1 kΩ load, @ 1 kHz
92 dB
All manuals and user guides at all-guides.com
Fastening Wing Nut
65A2190
Mounting Tube
31A2165
Rubber Isolation Rings (2)
Mic Cartidge (Cardioid)
Common Mode Rejection
10 to 100,000 kHz
45 dB, minimum
Preamplifier Output Clipping Level
at 1% THD
–7 dBV (0.5 V)
Mute Switch
−50 dBminimum
Logic Connections
Active low (≤1.0V), TTL compatible. Absolute maximum voltage:
LED IN
-0.7V to 50V.
Active low (≤0.5V), sinks up to 20mA, TTL compatible. Absolute
LOGIC-OUT
maximum voltage: -0.7V to 24V (up to 50V through 3kΩ).
Cable
6.1 m (20 ft), attached, unterminated, three shielded audio pairs and three shielded con-
ductors for logic control
Net Weight
594 g (1.3 lbs)
Environmental Conditions
Operating Temperature
–18–57°C (0–135°F)
Storage Temperature
–29–74°C (–20–165°F)
Relative Humidity 0–95%
Power Requirements
MX396/C-DUAL 48–52 V DC, 19.0 mA
MX396/C-TRI 48–52 V DC, 22.0 mA
66A405
R185B