Berner PRO-100 LOTMULTI Instrucciones De Manejo página 9

Operating Instructions
PRO-100 Soldering
Multi Art. 167059
Dear Customer!
Before commissioning, it is important to read the operating instructions
carefully.
ensure tip has cooled
before replacing cap.
IMPORTANT SAFETY INSTRUCTIONS
1.1 The body is filled with flammable butane gas under high pressure - therefore use with care!
1.2 Do not expose the soldering iron to temperatures above +50°C and do not place it directly in the sun.
1.3 Do not pierce or burn through the body.
1.4 If the gas output is very high, the flame or the catalyst is pulsating, you should make sure the gas control switch
is not set incorrectly. e.g. turned up too high!
1.5 Do not refill soldering iron or ignite near open flames, heaters, ovens, heaters, baking ovens or highly
flammable substances.
1.6 Keep the work area clean! Crowded areas and work benches invite damage to damage!
1.7 Put your soldering iron away when not in use. Store it in a dry, locked box, out of reach of children.
1.8 Be extremely careful because the temperature of the flame tip reaches over 1300°C (2500°F).
1.9 Be extremely careful because the flame is invisible in daylight or in strong light!
1.10 Use protective goggles.
1.11 Do not go too far! Always look at your balance and equilibrium.
1.12 Stay alert! Look carefully at what you are doing. Use it in the known sense! Do not handle when you are tired!
1.13 Do not touch the heated tip or guard of the soldering iron.
1.14 Do not leave the iron unattended during operation or while it is hot.
1.15 Always make sure that the tip has cooled down before storing it.
1.16 Do not put on lids during operation or when the tip is still hot.
1.17 Please use only in well ventilated areas.
1.18 Do not carry out repair work on the soldering iron yourself.
Warning
Do switch off and
U.S. Pat. 5,490,496
EN
Gas tank Filling valve
+