Publicidad
Idiomas disponibles
Idiomas disponibles
us_main.book.book Page 22 Thursday, October 13, 2022 8:55 AM
22 INSTALLATION
Upper hinge assembly
l
ON THE CABINET :
1
Now, pick up the upper hinge pivot removed
earlier and rotate it 180 degrees. Install the
hinge on the top left side of the cabinet.
2
Reinstall the door.
• Press in the side interlock button on the left
side and hold it down while you press the
hinge pivot into the hinge assembly on the
top right side. If the door has been
reassembled correctly, the lock rod will slide
back easily and lock the pivot in place. The
door is now ready to remount on the
opposite side of the dryer.
• While supporting the door, install the two
small hinge screws removed from the
hinge. Test the swing of the door to make
sure the hinges and latch are properly
aligned and that the door opens, closes and
latches properly in both directions.
• If the door doesn't operate smoothly,
remove the door and then the door cover to
check that the lock rods and interlock
buttons are properly mounted and aligned.
• The interlock buttons should be oriented
correctly and operating smoothly. The
interlock rods should be in the proper
Upper hinge pivot
m
n
Installing the Vent Kit
• Use long-sleeved gloves and safety glasses.
• Use a heavy metal vent.
• Do not use plastic or thin foil ducts.
• Clean old ducts before installing the appliance.
The appliance is configured to vent to the rear. It
can also vent to the bottom or side.
NOTE
• An adapter kit, part number 383EEL9001B, may
• Right-side venting is not available on gas
Side Venting
1
2
Upper hinge filler
position and should not overlap at the
contact point. (See steps 12-14.)
• If the door is damaged, or if the door does
notwork after reassembly, contact the call
centerat 1-800-243-0000.
WARNING
be purchased from your LG retailer. This kit
contains duct components necessary to change
the appliance vent location.
models.
Remove the rear exhaust duct retaining screw
and pull out the exhaust duct
a
b
Press the tabs on the knockout
carefully remove the knockout for the desired
vent opening. (Right-side venting is not
available on gas models.) Press the adapter
.
b
a
and
c
Publicidad
