Publicidad
Idiomas disponibles
Idiomas disponibles
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■
Fixing malfunctions
Malfunctions are usually due to small details. Before calling the
Technical Assistance Service you should bear in mind the
following advice and warnings.
Indicator
none
The indicators flash
The indicator - flashes on
the hotplate indicators
+ number /
+ num-
"§
š
ber /
¡
+ number
/
"‹
"Š
"ƒ
"...
"†
+ power level and
beep
and beep
"†
—‚
—ƒ
/
—„
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
26
Malfunction
The electric power supply has been cut off.
The appliance has not been correctly con-
nected following the connection diagram.
Electronic system malfunction.
The control panel is damp or an object is rest-
ing on it.
A fault has occurred in the electronic system. Briefly cover the control panel with your hand to con-
Electronic system malfunction.
There is an internal operating error.
The electronic system has overheated and
the corresponding hotplate has been
switched off.
The electronic system has overheated and all
hotplates have been switched off.
There is a hot pan on the control panel. It is
highly likely that the electronic system will
overheat.
There is a hot pan on the control panel. The
hotplate has switched off to protect the elec-
tronic system.
Incorrect supply voltage, outside normal oper-
ating limits.
The hotplate has overheated and has
switched off in order to protect its hob.
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
■
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.
Hob frame
In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Solution
Use other electrical appliances to check whether there
has been a power cut.
Check that the appliance has been connected cor-
rectly according to the connection diagram.
If none of the above checks resolve the malfunction,
contact the Technical Assistance Service.
Dry the control panel area or remove the object.
firm the malfunction.
Unplug the hob from the mains. Wait about
30 seconds before plugging it in again.*
Unplug the hob from the mains. Wait about
30 seconds before plugging it in again.*
Turn the control to the 0 setting. Wait until the elec-
tronic system has cooled down sufficiently before
switching the hotplate back on.*
Remove that pan. The malfunction indicator will switch
off shortly afterwards. You can carry on cooking.
Remove that pan. Wait a few seconds. Press any con-
trol panel. When the malfunction indicator switches off,
you can carry on cooking.
Contact your electricity board.
Wait until the electronic system has cooled down suffi-
ciently before switching it back on.
Publicidad
