Publicidad
Idiomas disponibles
Idiomas disponibles
into the base and connect the
charger to the mains.
• Remove the mains plug when
the battery is fully charged and
disconnect the battery from the
charger.
• Do not attempt to charge non-
rechargeable batteries in the
charger.
• Do not use any accessories
that are not recommended
by PARKSIDE. This can result
in electric shock or fire.
Charging the battery
Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury from
escaping electrolytic solution! After
eye/skin contact, rinse the affected
areas with water or a neutraliser
and consult a doctor.
Charge the battery in a dry
room only. Prior to attaching
the charger, check that the battery's
outer surface is clean and dry.
There is a risk of injury due to elec-
tric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
The rechargeable battery only
reaches its full capacity once it has
been charged several times.
• Charge the battery before using it for
the first time.
• Only use chargers from the (Parkside)
X 12 V Team series to recharge the bat-
tery.
• If the operating time is considerably
shortened despite charging, this shows
that the rechargeable battery is deplet-
ed and must be replaced. Only use an
original replacement battery from the
(Parkside) X 12 V Team series, which
can be purchased from the online shop
(see the "Spare parts" section).
• Always comply with the latest safety
information, as well as the regulations
and information relating to environmen-
tal protection.
• Defects resulting from improper handling
are not covered by the guarantee.
Inserting/removing the
battery
1. To remove the battery (1) from the de-
vice, press both release buttons (2) on
the battery and pull the battery out.
2. To insert the battery (1), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
Only insert the rechargeable
battery once the battery-op-
erated tool is ready for use.
Checking the battery charge
level
The battery's (1) charge level is indicated
by the charge state indicator.
• The charge level of the battery is indi-
cated by illumination of the correspond-
ing LED lights while the device is in
operation. Press and hold the power
button to view.
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red => Battery needs to be charged
GB MT
21
Publicidad
