Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Pole saw does
not cut properly
Bar and chain
run hot and
smoke.
40
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC
CAUSE
◾
Insufficient chain tension.
◾
The bar and chain are
skewed and not parallel to
the housing.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
◾
Chain cutters are dull.
SOLUTION
◾
Loosen the cover nut, turn the
tensioning screw clockwise until the
chain is correctly tensioned, and then
fully tighten the cover nut.
◾
Remove the battery pack and reinstall
the bar and saw chain according to
the section "REPLACING THE BAR
AND SAW CHAIN". Always remember
to keep the bar and chain parallel to
the mounting surface with one hand
before installing the side cover.
◾
Sharpen the chain cutters, following
the section "HOW TO SHARPEN THE
CUTTERS".
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND SAW
CHAIN".
◾
Remove the battery pack and replace
the chain following the section
"REPLACING THE BAR AND SAW
CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND SAW
CHAIN".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.
◾
Sharpen chain cutters by following
the section "HOW TO SHARPEN THE
CUTTERS".
Publicidad
