Publicidad
Idiomas disponibles
Idiomas disponibles
the previously selected speed.
F
2
FOR BATTERY TOOLS
The ambient temperature range for the use and stor-
age of tool and battery is 0 ℃-45 ℃ (32 ℉-113 ℉).
The recommended ambient temperature range for
the charging system during charging is 0 ℃-40 ℃
(32 ℉-104 ℉).
CLEANING THE TOOL
EN
Clean the tool regularly.
WARNING! Keep your product dry. Under
no circumstances spray with water.
-
To clean the tool, use only mild soap and a
damp cloth.
-
Do not use any type of detergent, cleaner or
solvent which may contain chemicals that
could seriously damage the plastic.
-
Self lubricating bearings are used in your
product, therefore lubrication is not required.
TECHNICAL DATA
Type
KG584 KG584.X (5 -designation of machinery,
representative of Cordless Blower)
Voltage
Maximum air volume
Maximum air velocity
Machine weight
(Bare tool)
**X=1-999, A-Z, M1-M9 there are only used for different
customers, there are no safe relevant changes between
these models.
***
Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
10
1
KG584 KG584.X **
40 V
MAX.
(2x20 V Max.)
***
900 m
/h
3
290 km/h
(with concentrator nozzle)
1.9 kg
SUGGESTED BATTERIES
AND CHARGERS
Category
Type
20V Battery
KAB04
KAC04
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.
VIBRATION INFORMATION
Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well main-
tained.
Using the correct accessory for the tool and ensur-
ing it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
Capacity
4.0Ah
4.0A
L
= 71.18 dB(A)
pA
3.0 dB(A)
L
= 80.1 dB(A)
wA
3.0 dB(A)
a
< 1.24 m/s
2
h
K=3 m/s²
Publicidad
