Zipper ZI-EWB500LI Instrucciones De Servicio página 28

14 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
14.1 Cleaning
The usage of certain solutions containing ingredients damaging metal surfaces as well as
the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution.
Never use running water or a high pressure cleaner to clean the machine.
• Clean the outer parts with a damp sponge.
• Never clean the electronic parts with water!
• Check the machine and remove the deposits and / or residues with a brush.
14.2 Maintenance
Unplug battery before all maintenance and settings!
Serious injury due to unintentional or automatic activation of the machine!
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be serviced
by trained persons only.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is
a pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
• Check regularly the condition of the security stickers. Replace them if required.
• Check regularly the condition of the machine.
• Store the machine in a closed, dry location.
14.2.1 Maintenance plan
After each workshift:
• Check the cables (tight fit, damage)
Monthly:
• Charge the battery: if the machine is stored for a longer period of time.
14.3 Storage
• Clean thoroughly all components before storage.
• Store all components separately in a dry area at not less than -10 ° C.
Important notes on storing the battery to avoid possible damage:
If the machine will not be used for a longer period of time, the battery should be disconnected and disassembled
from the machine. Before storage, the battery should be charged again. An exception to this rule are batteries
permanently installed in the machine, which should not be disassembled and simply charged with the charger
supplied. Batteries should be stored at room temperature (approx. 20° C) in a dry and frost-proof place. Avoid
large temperature fluctuations (e.g. do not expose battery to direct sunlight or store near heating systems).
Higher temperatures can lead to accelerated ageing and premature loss of function of the battery. If the battery
is not used for a longer period of time, check the charge level regularly (monthly, max. every 3 months). If
necessary, recharge the battery
14.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine, machine
components or operating equipment in the residual waste. If necessary, contact your
local authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
15 TROUBLESHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, UNPLUG THE BATTERY.
Trouble
No electrical support
No charging of battery
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
N O TE
C AU TI O N
N O TE
.
Possible cause
• Battery is not charged
• Motor stucks
• Power switch is damaged
• Broken or loose cables
• Loosen cable
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• Recharge battery
• Check motor
• Check switch
• Check cables
• Check cable connection
Solution
28
ZI-EWB500LI