Publicidad
Idiomas disponibles
Idiomas disponibles
your machine fails any of these checks
contact an Authorised Service Centre to
get it repaired.
GB
- Any use of the machine not expressly
e n v i s a g e d i n t h i s m a n u a l i s t o b e
considered improper and therefore a
source of risk to people and property.
THESE ARE HOT ENOUGH TO CAUSE
BURNS!
PROTECTIVE CLOTHING
While working with the brushcutter,
always use safety protective approved
clothing. The use of protective clothing does
not eliminate injury risks, but reduces the injury
effects in case of accident. Consult your trusted
supplier to choose an adequate equipment.
The clothing must be proper and not an obstacle.
Wear adherent protective clothing. Efco
protective jackets and dungarees are ideal.
Do not wear clothes, scarfs, ties or bracelets that
can stuck into twigs. Tie up and protect long hair
(example with foulards, caps, helmets, etc.).
Safety shoes having skid-proof sole and anti-
piercing insert.
Wear protective goggles or face screens!
Use protections against noises; for example
noise reduction ear guards or earplugs. The
use of protections for the ear requests much
more attention and caution, because the
perception of danger audio signals (screamings,
alarms, etc.) is limited.
Wear gloves that permit the maximum
absorption of vibrations.
Efco offers a complete range of safety
equipments.
2. SYMBOLS AND SAFETY WARNINGS (Fig.13)
1 - Read operator's instruction book before
operating this machine.
18
2 - Type of machine: ENGINE UNIT.
3 - CE conformity marking.
4 - Serial number.
5 - Year of manufacture.
6 - Primer bulb
3. MAIN COMPONENTS (Fig.1)
4 - Harness
5 - Fuel tank cap
6 - Purge Bulb
7 - Carburettor adjustment screws
8 - Muffler guard
9 - Spark plug
10 - Air filter
11 - Starter Handle
12 - Choke Lever
13 - Throttle trigger lockout
14 - STOP button
15 - Throttle lever
16 - Harness attachment
17 - Handle
18 - Shaft arm
19 - Attachments coupling
4. ASSEMBLY
FITTING THE HANDLE (Figs. 3)
Fit the handle onto the shaft arm and secure it
using screws (A). The handle position is calculated
depending on the requirements of the operator.
MOUNTING AND DEMOUNTING ATTACHMENTS
(FIG.4)
Mounting:
- Loosen coupling (E) by turning knob (C) counter-
clockwise;
- Align attachment tab (B) with channel (A) in
coupling (E);
- Fit attachment tube (D) into coupling (E) as far
as broken line (F);
NOTE To facilitate the procedure rotate the
attachment cutting tool to engage the drive shaft
with the fitting. Check to ensure there is no dirt
or debris in the coupling;
- Tighten knob (C) fully by turning it clockwise.
Demounting:
Release the coupling by turning knob (C) counter-
clockwise and remove the attachment.
Publicidad
