Publicidad
Idiomas disponibles
Idiomas disponibles
Interconnections
Installing one or more batteries is necessary to work at 12.6 Volts, to supply the pre amplifier
and other equipment that require this same voltage as Head Unit, crossover, equalizers,
amplifiers, etc. As shown in the scheme .
VEHICLE
ORIGINAL BATTERY
To avoid electrical shock in the
bodywork of the vehicle, it is
extremely turn off the two
c i r c u i t b r e a k e r s b e f o r e
c o n n e c t i n g t h e s y s t e m
batteries in the HIGH VOLTAGE
series. Turn on them again only
when all system is turned off.
POWER BATTERY
HEAD UNIT AND
PRE AMPLIFIER
12.6 VDC
CIRCUIT BREAKER
130A
IT IS MANDATORY INSTALLATION OF
CIRCUIT BREAKER - 130A
* Gauge for the output cable is 21mm², calculated a maximum length of 2m.
Attention! Do not use the vehicle chassis as system grounding point.
Is forbidden the locomotion of the vehicle with this in sound system in operation. For maximum power
and amplifier performance , use 18 x 130 amps batteries at least.
VEHICLE
ALTERNATOR
. CROSSOVER;
. EQUALIZER
. AMPLIFIER - 12.6VDC
. ETC...
2.5mm²
CIRCUIT BREAKER
CIRCUIT BREAKER
130A
Cable RCA
Taramps
OUTPUT
FRONT/REAR (L/R)
Mp3
00:0000
032
2.5mm²
130A
21mm²
CIRCUIT BREAKER
21mm²
RELÉ 10A
Amplificador
2
PRE AMP.
12.6 VDC
130A
HIGH VOLTAGE
06
Publicidad
