Nilfisk VL500 Serie Instrucciones De Uso página 11

Only applicable to UK.
Please read these essential
instructions
Only applicable to UK.
Regular servicing and
inspection
Only applicable to UK.
Electrical connections
Original instruction
This vacuum cleaner is designed, developed and rigorously tested to
function efficiently and safely when properly maintained and used in ac-
cordance with the following instructions. These instructions have been
prepared with safety and efficiency paramount.
The machine operator must be trained by a suitably qualified instructor
and must understand these instructions for use, and be made aware of
any relevant regulations and legislation in force at the time of use.
This machine is not suitable for use in explosive or inflamma-
ble atmospheres or where such atmospheres are likely to be
produced by the presence of volatile liquid or inflammable gas
or vapour.
In no circumstances should the power supply cord be
wrapped around fingers or any part of the operators person.
The electrical supply plug must not be subjected to undue
stress by pulling on the power supply cord.
Your MACHINE must only be connected to an electrical sup-
ply of the same voltage and frequency as indicated on the
rating plate. Ensure that the plug fitted to the end of the power
supply cord is suitable for your supply socket, if not refer
to the information contained in 'Electrical Connections', or
consult a qualified electrician. The electrical installation from
which the supply is drawn must be maintained to current Insti-
tute of Electrical Engineers wiring regulations.
Regular servicing and inspection of your machine must be carried out
by suitably qualified personnel in accordance with relevant legislation
and regulations. In particular, electrical tests for earth continuity, insula-
tion resistance, and condition of the flexible cord should be checked
frequently.
In the event of any defect, the machine MUST be withdrawn from ser-
vice, completely checked and repaired by an authorized service techni-
cian.
DOUBLE-INSULATED MACHINES - IMPORTANT:
This 240 volt 50 Hz. machine are fitted with a 13 amp. 3 pin
moulded plug. The plug is fitted with a 13 amp. detachable
fuse. The correct replacement for the fuse is identified by
marking or colour coding. Only fuses that are ASTA approved
to BS 1362 should be fitted. Never use the plug without the
fuse cover fitted. Replacement fuse covers are available at
any electrical retail outlet.
If the available socket outlet is not suitable for the plug supplied, the
plug must be cut off and an appropriate plug fitted. The plug thus cut off
MUST BE DESTROYED for safety reasons before being disposed of.
Machines built for other voltages and frequencies are not normally sup-
plied with a fitted plug.
If it is necessary to fit a plug, the wires in this power supply cord are
coloured in accordance with the following code:
CAUTION
CAUTION
11