Publicidad
10
Plug the Adapter Cable into the Power Adapter (10a). Plug the Power Cord into the Power Adapter
(10b). Plug both ends of Cords from each Lifting Column into the back of the Hand Switch (10c).
If the Lifting Column Cord is not long enough, use the Extension Cord to reach the Hand Switch.
Install other end of Adapter Cable into the back of the Hand Switch (10c).
Note: As an option, use the provided (6) Cable Ties to secure cables to underside of worksurface
(10d), with either double sided tape or the (6) ST4.2 X 12mm Flat Head Wood Screws.
10a
Motor Cord Port
Power Adaptor Port
Motor Cord Port
Lifting Column Cord
Adapter Cable
Lifting Column Cord
11
Flip your table right side up and plug into outlet. Reset the desk per instructions in following section.
YOU MUST RESET THE DESK BEFORE USE. FOLLOW INSTRUCTIONS ON INITIAL SETUP/RESET
14
10c
UNDER HAND SWITCH (SEE PG. 15 or 16)
10b
10d
Publicidad
