Publicidad
Idiomas disponibles
Idiomas disponibles
If you are installing your refrigerator next to a fixed wall, leave sufficient
space on the hinge side to allow for the door to swing open.
Never install your refrigerator near heat source and direct sun shins.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your refrigerator into its final location, it is important
to make sure you have the proper electrical connection.
Recommended Earthling Method
A 220/240V/50 Hz AC only 10 ampere fused and properly earthed
electrical supply is required. It is recommended that a separate circuit
serving only this appliance be provided. Use receptacles which cannot
be turned off with a switch or pull chain. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the refrigerator control to OFF and then
disconnect the refrigerator from the electrical source. When you are
finished, connect the refrigerator to the electrical source and reset the
control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation, the doors may not
close or seal properly, causing cooling, frost, or moisture problems. It is
very important of the refrigerator to be level in order to function
properly.
To level your refrigerator, you may either turn the level leg clockwise to
raise that side to the refrigerator or turn counter – clockwise to lower
that side.
25
Publicidad
