Remington RM112ST Manual Del Propietário página 18

14 |
6 troubleshooting
WARNING: Unplug trimmer/edger from power source before servicing.
Severe injury or death could occur from fire, electrical shock, or rotating line.
Note: For additional help, visit
www.remingtonpowertools.com.
OBSERVED FAULT
Motor does not run when you turn trig-
ger switch on
Line does not feed when you tap the
line advance button
Replacement Spool
Part Number Description
731-07488 Replacement Spool
with Line
WARNING: Use of non-Rem-
ington® parts or accessories may
cause personal injury or damage
to the unit.
POSSIBLE CAUSE
1. Extension cord connection is loose
1. All line has been used on spool
2. Line has retracted into spool
3. Line is caught or tangled on spool
and will not feed
REMEDY
1. Check cord connection at electri-
cal outlet and at rear of trimmer/
edger
1. Install new line on spool, following
steps under Replacing Trimmer/
Edger Line, page 8
2. Remove spool and pull line out,
then replace spool
3. Remove spool, loosen and un-
tangle line, then replace spool