Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink
or at the main water supply. Disconnect the supply
lines. Remove the existing faucet from the sink.
Clean and dry the surface area where the new faucet
will be mounted.
2.
Mount the faucet body (A) to the laundry tub or utility
sink directly or using a mounting block (not included).
The two mounting tabs (2.1) should be placed over the
edge of the basin, facing the FRONT of the laundry tub.
The single tab should face the rear of the tub.
3.
Remove the union nuts (AA) from the faucet (A) and
slide them up the hot and cold water supply pipes.
Apply thread seal tape to all threaded connections in
a clockwise direction or use pipe joint compound.
Hardware Used
AA
Union nut
1
2
3
x 2
4
A
2.1
AA
A
Publicidad
