Publicidad
Idiomas disponibles
Idiomas disponibles
emove 1 of 2 screws from the bottom of the hanger
R
bracket (1) and loosen the other one a half turn from the
screw head.
Slide the canopy (3) up to the hanger bracket and place the
key hole on the canopy over the screw on the hanger
bracket, turn the canopy until it locks in place at the narrow
section of the key holes.
Align the circular hole on the canopy with the remaining
hole on the hanger bracket, secure by tightening the two screws.
Attach the canopy cover (4) to the canopy, and turn it clock wise to secure it.
Remote control only:
Slide the cover of the battery compartment on the remote, and install a
12 Volt A23 battery (included). Please make sure the polarity of battery
is correct. To prevent damage to transmitter, remove the battery if it is
not used for long periods of time. Fig. 12
Your DC brushless motor is equipped with a self-learning and pre-paring frequency function remote
control. Restore power to the ceiling fan and test the transmitter as below for proper operation:
A. 1, 2, 3, 4, 5 and 6 button:
These six buttons are used to set the fan speed as follows:
1=minimum speed
2=low speed
3=medium low speed
4=medium speed
5=medium high speed
6=high speed
B.
Reverse button:
This button is used to change the direction of the rotation of the blades;
forward for warm weather or reverse for cold weather.
NOTE: To change the direction of the rotation of the blades, the fan must be in
operation mode.
C.
Button:
This button turns the power off and on to the fan.
D.
Button: (not valid with this fan models)
All manuals and user guides at all-guides.com
FINISHING THE INSTALLATION
USING YOUR CEILING FAN
8
Fig. 11
Fig. 12
Fig. 13
Publicidad
