Toro 51955 Manual Del Operador página 21

Idle Speed Adjustment
See Figure 19.
WARNING:
The blade/cutting head will move when adjusting
the idle speed. Wear all protective clothing and
keep all bystanders, children, and pets at least 50
ft. away. Make adjustments with the unit support-
ed by hand so that the blade/cutting head does
not contact the ground or any object. Keep all
parts of your body away from the blade/cutting
head and muffler. Failure to follow these instruc-
tions could result in serious personal injury.
If the cutting attachment turns at idle, the idle speed screw
needs adjusting on the engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the cut-
ting attachment movement. If the cutting attachment still
moves at idle speed, contact a service dealer for adjustment
and discontinue use until the repair is made.
WARNING:
The cutting attachment should never turn at idle.
Turn the idle speed screw counterclockwise
to reduce the idle RPM and stop the cutting
attachment, or contact a service dealer for
adjustment and discontinue use until the repair
is made. Serious personal injury may result
from the cutting attachment turning at idle.
Storing the Product
Storing the product differs depending on the amount of time
it will be in storage.
Note: If the product includes another attachment, place the
storage cap on the end of the attachment shaft and hang it up
to store.
To Store the Product Short Term:
Follow these steps to store the product short term.
1. Clean all foreign material from the product.
2. Store the product in a well-ventilated place that is inac-
cessible to children.
To Store the Product Long Term:
If you do not intend to use the product for more than one
month, follow the storage procedures below.
Follow these steps to store the product long term.
1. Drain all of the fuel from the tank into a container ap-
proved for gasoline.
2. Run the engine until it stops.
3. Clean all foreign material from the product.
4. Store the product in a well-ventilated place that is inac-
cessible to children.
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Note: Abide by all federal and local regulations for the
safe storage and handling of gasoline.
Maintenance
Idle Speed
Screw
Straight Shaft
Curved Shaft
Transporting the Product
Follow these steps to transport the product.
1. Drain the fuel mixture into a container that is approved
for use with gasoline.
2. Carry the product by the front handle.
3. Secure the product in your vehicle or on a trailer.
Installing Reel-Easy
See Figures 20 - 21.
 Stop the engine and disconnect the spark plug wire.
 Open the Reel Easy string head by depressing the
latches on each side. The contents of the string head are
spring loaded, so keep your other hand over the string
head cover while depressing the latches.
 Remove the string head cover, knob, and spool and set
aside.
Figure 19
Cover
Latches
Knob
Spool
Spring
Hex Bolt
String Head
Latch
Opening
Figure 20
String Head
™
21