Parkside PBK 4 B3 Traducción Del Manual De Instrucción Original página 61

• Do not cut with blunt or worn blades or
chains as otherwise you will overload
the engine and gears of your device.
• Check the covers and protective devic-
es for damage and correct fit. Replace
these if necessary.
Cleaning
• Clean the device after each use. Clean
the motor housing with a damp cloth
or a brush. The device must neither be
sprayed with water nor be put into wa-
ter.
• Keep the ventilation slits of the device
clean. Use a damp cloth or brush to do
this.
Maintenance intervals table
Machine part
Complete machine
Accessible screws
and nuts
Air filter
Fuel filter
Spark plug
Fuel hoses
Operating handle
Saw chain
Blade bar
Cutting head
Coupling
Gears
Action
Check condition, replace
damaged parts as needed
Check, tighten
Clean or replace
Replace
Clean/adjust/replace
Check, replace as needed
Check for function
Check, oil, regrind or re-
place if necessary
Check, turn over, clean, oil
Check correct installation
Check that the device is sta-
tionary while idle
Lubrication
• Do not use any cleaning agents or
solvents. This could damage the device
irreparably. Chemical substances may
attack the plastic parts of the machine.
• Always keep the device clean.
After each use of the
device, you must
- clean the blade
(with an oily cloth);
- oil the cutter bar
with an oil can/spray.
Service intervals
Carefully perform the maintenance tasks
listed in the following table on a regular
basis. Regular servicing of your unit
will extend the life of your equipment.
Additionally, you will achieve optimum
cutting performance and prevent accidents.
Before use







GB MT
Hours of use
10 20






61