Elframo D36 Serie Manual Del Usuario página 27

•
Clean the tank filters and the pump filter.
•
Dismantle the upper and lower washing and rinsing arms by unscrewing their central fastening ring nut.
•
Check and clean all the sprayers.
•
Thoroughly clean the tank.
•
Place again all the parts that were removed, proceeding in the reverse order.
•
Leave the door open for the entire period that the appliance is at rest.
•
Clean the outer surfaces of the appliance with soap and water. Rinse the surfaces and dry them carefully.
NOTE: never clean stainless steel with steel shavings, wool or brushes. Lime deposits and scale will build up on
the inner surfaces of the boiler tank, the pipelines and tank due to calcium and magnesium salts present in the
water. These scales and deposits can prejudice proper appliance operation. The appliance must be periodically
descaled by expert personnel. If the machine fails to operate correctly or breaks down, disconnect from the
electricity mains and call a qualified service center.
24. Machine idle
Whenever the appliance will be inactive for a long period of time, follow these steps for hygiene purposes:
•
fill the machine with water but without any detergent
•
make a few wash cycles without any dishes
•
drain the machine completely
Repeat these steps until the drained water is clean and free of any residues of dirt or detergent. Protect the outer
surfaces with Vaseline oil if the machine will be inactive for a very long period. Have an expert draining all the water
out from the boiler and the internal circuits to avoid the danger of ice formation.
25. Sterilization
At least once a week, sterilize the machine by using specific disinfectants, finishing with repeated rinsing for
several minutes (fill the tank without the over-flow).
Note: After having cut-off mains power only skilled personnel may remove the panels.
The manufacturer cannot be held liable for any accident or anomaly caused by any non-observance of the instructions
and safety rules provided in this manual by either the user or the technician responsible for installing the machine.
THE MANUFACTURER CANNOT BE HELD LIABLE FOR ANY LOSS ARISING FROM ANY INACCURACIES IN THIS
MANUAL AS THE RESULT OF PRINTING OR TYPING ERRORS. THE MANUFACTURER ALSO RESERVES THE RIGHT
TO CHANGE THE SPECIFICATIONS OF THIS PRODUCT WHERE USEFUL OR NECESSARY WITHOUT THIS AFFECTING
ITS
Istruzioni originali Original instructions Instructions originales Originalanleitungen Instrucciones originales Rev. 3.00 del 14/02/2020 - pag. 27 di 72
MAIN
EN
CHARACTERISTICS.