Memco Base3 Guia De Instalacion página 3

Fixing the unit behind the COP
Follow the simple steps below to install the C100 Base behind the COP panel.
1. Drill fixing holes
The external LED indicators have a diameter of 6.35mm.
The C100 BASE is supplied with a self-adhesive gasket on the face of the unit. In the absence of studs or screw holes in
the COP the gasket may be used to affix the C100 BASE to the COP.
To obtain optimum adhesion, the bonding surfaces must be clean, dry and well unified. A typical surface cleaning solvent
is isopropyl alcohol. Use proper safety precautions for handling solvents.
Programming Options
+ One touch programming (programming tool)
+
Programming through the full product menu (programming tool)
+ Remotely via ETR software or a touch-tone telephone handset
Programming, at the touch of a button
1. Plug the programming tool into the C100 unit.
2. If the C100 programming unit has a programming template set up,
the following message 'One-touch programming?' will appear.

3. Press the button and the programming will be downloaded to
the C100 unit automatically.
If a location message needs to be recorded on the unit, press 1 to go into
programming mode and record the message in the following location on the
programming menu Messages> Location.
Programming is now complete. You need only refer to the below sections of the
guide if more advanced programming is required.
2. Cut the grill pattern and
LED indicator holes
3. Fix the unit in place