Memco Base3 Guia De Instalacion página 4

Programming controls and full menu
If you are not able to utilise the one touch programming, program the unit using the full product menu. Details of the
menu controls and quick start menu can be found below:
Menu controls
Scroll up
Scroll Down

Forward / Accept

Back / Cancel
Quickstart menu
1. Alarm No 1 + Using the keypad, enter the first alarm telephone
number. If connecting the unit to a Hotline, enter 0
instead of a full telephone number
+ Select the protocol required from the list which
includes Guided, Unguided, Memco, P100, and
Contact ID. If connecting to a hotline then no
telephone number is required, and this will need to
be programmed by ticking 'Hotline' in Settings> Sys
Config> Hotline
2. Tech. No + Using the keypad, enter the telephone number of
the software system for Technical calls
+ Select the protocol required from the list
+
The unit will ask if you want to use the same number
for background calls, press
reject.
3. Background No +
If you have accepted to copy the telephone number
from the Tech No, you can skip this option
+ If not, enter the telephone number required
+
Select the protocol required from the list.
4. Volume +
If you require a volume different to the default
volume, press the up and down arrows until the
desired volume is reached
+ Press
5. Location +
To record a Location Message, press 2 to start
recording
+
Press
+ Press 1 to play the message back
6. ID Code +
Only requires input if you are using GlobalNet to
monitor the C100 unit
+
If so, add 3 digit Globalnet customer number to unit
ID code, which is written on the bottom of the unit
ie 109 463768
7. Network ID + If you are attaching more than one C100 unit to a
single telephone line, you need to assign each unit a
network ID
+ The first unit would have an ID code of 1, the second
unit 2, the third unit 3, and so on.
To exit programming mode Press
select the action required upon exiting from this list.

to accept and

to confirm

to end the recording

twice, and

to