Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The burners do not
Surface burner
burn evenly.
components and caps are
not assembled correctly
and level.
The surface burners are
dirty.
Very large or
The wrong burner orifice
yellow surface
is installed.
burner flames.
Surface burners
The oven door lock is
light but oven
turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
NX60BB8715QNAP_AP_DG68-01493A-01.indb 49
NX60BB8715QNAP_AP_DG68-01493A-01.indb 49
Cause
Action
See page 42.
Clean the surface burner
components.
(See page 41.)
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and Tap and hold START for
3 seconds. The oven will beep
and the Lock icon will turn off.
Call a qualified service
technician.
Oven
Problem
Cause
The oven control
There may be an issue
beeps and displays
with your oven. See the
an information
"Information codes" chart
code.
on page 53.
The oven will not
The oven is not
turn on.
completely plugged into
the electrical outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
The oven
The oven thermostat
temperature is too
needs adjustment.
hot or cold.
Action
Tap OFF, and then restart the
oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
Make sure the electrical plug
is fully inserted into a live,
properly grounded outlet.
Replace the fuse or reset the
circuit breaker.
See page 34.
English 49
2023-01-20 오전 11:17:51
2023-01-20 오전 11:17:51
Publicidad
