Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUST INSTRUCTIONS
74
81
5
70
84
A
B
4
71
9
Adjust handlebar
height
9
Loose
-19-
Adjust seat
Unscrew knob(70),then change the
height of seat tube(5)to the position
you need to,ensure the knob(70) stick
into the right hole.unscrew
knob(81),move seat cushion to wher-
ever you want it to be,then fasten it by
knob(81) in clockwise.
Adjust handlebar
Unscrew knob(9),move center post(4)
+
to wherever you want it to be,ensure
71
-
the knob(9) stick into the right hole,-
fasten it by knob(9) in clockwise.
Adjust resistance
Screw the knob(71) clockwise to
increase resistance;screw the
knob(71) anti-clockwise to reduce
resistance. Press down the knob(71)
to emergency braking.
Adjust balance
To achieve a smooth and comfortable
ride, you must ensure that the stability
of the bike is stable. If you notice that
the bike is unbalanced in use, you
should adjust the front and rear floor
mats. It is located at the front and rear
of the bike under the front and rear
Tight
bottom tubes. To do this, turn the foot
pad (84) clockwise (A direction) by
hand to loosen and adjust the height.
Pull
Turn the screw anti-clockwise (B) to
reduce the height until it is parallel to
the surface of the bike. When you
adjust the front and rear floor MATS,
do the same as above to make sure
the front and rear floor are flat.
Repeat this procedure if necessary to
adjust the balance.
Publicidad
