TEFAL AQUASPEED FV53 Serie Manual Del Usuario página 7

1800119869 FV53XX E0 FTN TE_110x154 14/12/10 11:29 Page3
• Never use water containing additives (starch, scents, softeners, etc.),
or water produced by condensation (e.g. water from tumble-driers,
refrigerators, air conditioners, rain water). The types of water contain
organic waste or mineral elements that can cause spitting, brown
staining, or premature wear of the appliance.
Fill the tank up to the
"MAX".
Never fill the appliance by
holding it directly under
the tap.
Do not remove the anti-
scale valve to fill the water
tank.
Use
Adjust the temperature and the steam
• Set the thermostat control – fig.4, referring to the table below.
• The thermostat light comes on. It will go out when the soleplate is hot enough – fig.5.
FABRIC
LINEN
COTTON
WOOL
SILK / SYNTHETIC (Polyester,
Acetate, Acrylic, Nylon)
RECOMMENDATIONS
• Select setting and save 20% energy compare with the maximum position.
• Your iron heats up quickly: so begin by ironing fabrics that are ironed at low
temperatures first, then go on to those requiring a higher temperature,
• If you turn down the thermostat, wait until the thermostat light comes back on
before beginning to iron again,
• When ironing fabrics with mixed fibres, set the ironing temperature for the most
delicate fibre. For delicate fabrics we recommend testing the fabric first on an
inconspicious place eg (inside the hem).
Make sure that there is
water in the tank before
using this button.
Obtain more steam
• Turn the thermostat to "MAX" or "
• Operate the Power zone
• To avoid drips, leave an interval of a few seconds between operations.
Hold the iron a few
centimetres from the fabric
to avoid burning delicate
fabrics.
Every five pulses return the
iron to a horizontal position.
• Unplug your iron before filling it.
• Set the steam control to
• Take the iron in one hand and tilt it slightly, with the point uppermost.
• Open the water tank lid – fig.2.
• Fill the tank up to the "MAX" line – fig.3.
• Close the flap of the water tank.
POSITION OF
THERMOSTAT CURSOR
MAX
•••
••
•
• Whether steam or dry ironing, you are able to use the spray button to dampen
laundry to remove stubborn creases –
•••
".
trigger from time to time – fig.7.
• Hang the garment on a hanger and hold the fabric slightly taut with one hand. The
steam is very hot, so you should always do this with the garment on a hanger – never
iron clothes which someone is wearing.
• Set the thermostat control to "MAX" –
• Operate the Power zone
to bottom – fig.9.
3
If your water is very hard, it is
possible to mix tap water with store-
bought distilled or demineralised
water in the following proportions :
- 50% tap water,
- 50% distilled or demineralised water.
Filling the water tank
– fig.1.
STEAM SETTING POSITION
In order to avoid water
dripping from the iron onto
the linen:
- Turn off the steam when
ironing silk or synthetic
fabrics.
- Set it at the minimum
position for wool.
Spray Function
fig.6.
Vertical steam ironing
fig.8.
trigger by pulsing – fig.7 moving the iron from top
EN
DE
FR
NL
ES
PT
IT
DA
SV
NO
FI
EL
HU
CS
= STEAM ZONE
SK
SL
SR
HR
RO
(spray)
BG
TR
UK
RU
PL
ET
LV
LT