Kicker IX.5 Serie Manual Del Propietário página 3

Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
The IX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown below (make sure you set
the IX amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the
low-level RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO".
Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this
wiring, cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. Install
a second fuse within 18" (45cm) of the amplifi er. If you ever need to remove the amplifi er from the vehicle after it
has been installed, the ground wire should be the last wire disconnected from the amplifi er--just the opposite as
when you installed it.
Model External Fuse
(sold separately)
IX1000.5 1 x 100 Ampere
AMP1
L+ L– R+ R–
BRIDGED
24"
(60cm)
bare-metal
chassis ground
2011 IX 1000.5 RevF.indd 3 2011 IX 1000.5 RevF.indd 3
shield
Power/Ground Wire
4 Gauge
remote turn-on
(see page 5)
POWER
AMP1 AMP2 SUB
GND REM +12V
external fuse
to amplifi er
KICKER ZISL
OR
KICKER Wiring Kit
PK4, CK4, ZCK4
AMP2
AUTO
REMOTE BASS
TURN ON
L+ L– R+
12V DC AUDIO
L
OFFSET
INPUT FADER SUB
LEVEL INPUT
R
LO OFF AMP2
BRIDGED
HI ON SUB
18"
(45cm)
battery
to amplifi er
source unit high-level
speaker outputs
SUB
R– + –
12V
11/5/2010 12:22:23 PM 11/5/2010 12:22:23 PM
3