Levolor Sheer Shadings Instalación página 10

INSTALLATION
Install the Shading
• Position the shading so that the
front (colored fabric) faces you.
• Slide the headrail into the
installation brackets so the edge
of the headrail is between the lever
and the bracket, as shown.
• Firmly push the headrail into each bracket until it clicks and the lever
snaps to the right side of the bracket.
IMPORTANT: Carefully pull on the headrail at each bracket to ensure it is
installed securely.
Attach the Magnetic Hold-Down Brackets (Optional)
• Lower the shading while keeping the vanes closed.
• Place the magnetic hold-down bracket onto the bottom rail just
inside the end cap, oriented as shown.
• Hold the bracket while opening and closing the vanes (it may
be necessary to have someone else assist you). Adjust the
bracket to the best overall position.
• Mark the screw location using the mounting options shown below.
— The screw should be placed in the middle of the channel. This will
allow for adjustment.
• Drill the screw holes using a
IMPORTANT: Use drywall anchors when mounting into drywall.
• Attach the hold-down brackets to the mounting surface
using the screws provided.
• If necessary, adjust bracket height by loosening the screw
and sliding the bracket up or down.
Outside Mount
Preferred
10
Sheer Shadings Motorized Operating System
/ " drill bit.
3
32
Alternate
Lever
Installation
Bracket
Inside Mount
Preferred
Headrail
Slide the Headrail
between the Lever
and the Bracket.
Bottom
Rail
Hold-Down
Bracket
Adjust the
bracket
using the
channel.
Alternate