Descargar Imprimir esta página

ECCOTEMP EL10 Instalación, Uso Y Cuidado página 14

Ocultar thumbs Ver también para EL10:

Publicidad

Idiomas disponibles

Idiomas disponibles

Rain Cap Inspection
Be sure to turn the unit off and disconnect the water supply before performing any housekeeping tasks
to this tankless water heater. Vacuum around the tankless water heater for dust, dirt and lint on a regular
basis. Clean the tankless water heater and front panel by using a damp soft cloth with a few drops of mild
detergent and gently wiping the surfaces of the unit. Wipe any remaining moisture with a dry soft cloth.
Storage
When not in use, your portable tankless water heater should be stored away in a climate-controlled area.
WARNING: Item should not be left or stored in freezing conditions (at or below 32°F / 0°C). Internal
damage can occur.
Upon completion of use, prepare your water heater for storage:
1.
Turn OFF water and gas supply and then disconnect from water heater.
2.
Unscrew the drain valve (ribbed cylindrical stem next to the water input valve) to ensure draining of
water.
3.
Remove the screen at the end of the water inlet pipe and clean. Return screen after cleaning. (see
housekeeping section above for instructions)
4.
Store tankless water heater in a climate-controlled area.
When the tankless water heater is not in use and remains connected to the LPG supply cylinder, the tankless
water heater and cylinder must be stored outdoors, in a well ventilated space, out of the reach of children,
and must not be stored in a building, garage or any other enclosed area.
Storage of the tankless water heater indoors is permissible only if the cylinder is disconnected and removed
from the water heater.
LPG cylinders must be stored outdoors, in a well-ventilated space, out of the reach of children, and must not
be stored in a building, garage or any other enclosed area.
Cleaning the Water Screen
1.
Make sure the water heater is OFF.
2.
Disconnect the water supply from the water heater.
3.
Locate the screen at the end of the water inlet pipe and gently
remove with a screwdriver.
4.
Rinse the screen in a sink or with a hose to remove any debris.
5.
Return the screen by gently inserting back into the end of the water
inlet pipe.
6.
Reconnect the water supply and turn ON the water heater.
7.
Clean the water screen on a monthly basis.
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED, NOR HAS IT BEEN TESTED FOR ANY PERMANENT OR INDOOR INSTALLATION. THIS
MODEL IS PART OF OUR PORTABLE, OUTDOOR SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM, DRY PLACE AFTER EVERY
USE. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. VISIT SUPPORT.ECCOTEMP.COM FOR THE
14
Shop Online: Eccotemp.com
LATEST VERSION OF THE MANUAL AND WARRANTY.
Support: Support.Eccotemp.com
105
F
GAS
WATER
Internal
Water Inlet
Screen
Store Locator: Eccotemp.com/locator

Publicidad

loading

Este manual también es adecuado para:

El7El5El10nr