ROBBE Arrow Plus 222 Instrucciones De Uso página 4

Fig. 23
Stick length adjustment
Fig. 24
Adjusting the spring tension of the self-neutralising sticks.
Fig. 25
Adjusting the spring tension of the non-neutralising stick.
Fig. 26:
Transmitter stick mode
Stick mode 1
©
Arrow Plus 222, Arrow Plus Trainer
Stick mode 2
Preparations for the first flight
Figs. 27 - 29
Set the throttle stick to Idle (towards you), and move the throttle
trim back to its end-point. If you ignore this, the motor could not
start running.
Switch the transmitter on. The unit beeps, and the bars in the trim
display then start to cycle.
Connect the flight battery in the model. Do not move the model
or the transmitter sticks.
You will hear a second beep when the cycling of the trim displays
ceases, and the LED on the receiver lights up. The system and
the receiver are now ready for use.
Initialisation error
Error
No initialisation
Throttle stick and trim
not at bottom end-point
Transmitter battery / cells flat
No receiver power supply
Transmitter / receiver not working
Fig. 30:
Fig. 31, 32:
The swashplate must be exactly horizontal when viewed
from the side and from the front.
Fig. 33
Remedy
Disconnect battery, switch transmitter off,
switch system on again
Move stick and trim to bottom end-point
Replace dry cells / recharge battery
Charge flight battery
Have units checked by Service department.
No. S2512
No. S2513